Help with trigger

Hi,

Seems to be starting at the 30sec after the off rather than at wait...

Hi
It's working fine.
It sets markets inplay refresh rate to 0.3 33 seconds before end of race.

You need to be refreshing (monitoring) the market before the off so it can pick up inplay time required for the calculations.

Also default idle and inplay rates should be 1 second or quicker for accurate timing.

but it's working OK.

I had the refresh trigger in another block when testing- does this make the difference?

It should not make any difference. Attached is the one I was testing, which effectively is the same as yours and it works fine.

Check the following settings:
Settings > Betting Options > Banking > all unticked
Settings > Betting Options > Triggers > No triggering till unticked
Settings > Monitoring Options > Start monitoring x before beginning ticked
Settings > Monitoring Options > Idle and inplay refresh rates 1 sec
Settings > Test Mode > Delay placing... unticked

What distance race did you test on. If 5f it will trigger around 30s in.

My idle refresh was at 2secs and i had half sec delay in test.

Will try again this afty....

Will the test delay effect the way it works much? as i use the delay so when i go live the results are similar...

Yes you are right- it works just as it should.

Thanks for all your help

Is it possible to set a command for the final third?

I thought "sel trigger expression timetoend is less than racetime/3" would work but it doesn't?

Hi
Just waiting for some markets to test it. Should be up later.

Hi
In this version the race distance is multiplied by 0.66 (you can adjust this in a constant)
so when TimeToEnd is zero, we are actually two thirds into the race and the trigger will fire.
The wait variable should be set close to zero.

Please try in test mode.

Thanks again Mark

Help with trigger

Hello Guest